Roland VersaCAMM VP-540 Service Notes page 234

*3
Not assured when the print heater or dryer is used.
*4
The following conditions must be met:
Media type: Media specified by Roland DG Corp.
Roll media must be loaded on the shaft.
[PREFEED] menu item must be set to "ENABLE."
Side margins: 25 mm or more for both the left and right margins
Front margin: 35 mm or more
Excluding expansion/contraction of the media
Range for assured repetition accuracy
54-inch model
For media with a width exceeding 610 mm: Length 4,000 mm
For media with a width of 610 mm or less: Length 8,000 mm
30-inch model
Length 3,000 mm
*5
Provided that media length is under 3,000 mm
Temperature: 25 C (77 F)
Excluding possible shift caused by expansion/contraction of the media and/or by reloading the media.
*6
Media type : Roland PET film
Data size: 1,000 mm in the media-feed direction, 1,346 mm (54-inch model) or 736 mm (30-inch model) in the carriage-move-
ment direction
No lamination
Automatic detection of crop marks at 4 points when media is reloaded.
During cutting, [PREFEED] menu item must be set to "ENABLE."
Temperature: 25 C (77 F)
Excludes the effects of slanted movement and of expansion and contraction of the media.
7
*7
Warm-up is required after powerup. This may require 5 to 20 minutes, depending on the operating environment.
Depending on the ambient temperature and media width, the preset temperature may fail to be reached.
*8
Depth when the included ink-cartridge tray is installed is 1,000 mm.
*9
Operating environment
Humidity (%)
(no condensation)
80
55
35
0 15 20
(59) (68)
Temperature
Use in an operating environment
with this range.
27 32 C ( F)
(80.6) (89.6)
7-14