Fix the Tool Carriage Assy to the Tool Carriage Board
15
Stay.
Fix the Tool Carriage Board with the 2 screws as shown
16
in the figure.
Connect the Crop Mark Sensor, Pinch Roller Sensor,
17
and Solenoid wirings.
Move the Head Carriage in a whole width of the Guide Rail several times to remove the slack in the Carriage Belt.
18
Then, carry out the following adjustments.
1. [4-14 BELT TENSION ADJUSTMENT]
2. [4-15 BELT POSITION ADJUSTMENT]
3. [4-5 LIMIT POSITION & CUT DOWN POSITION INITIALIZE]
4. [4-7 FLUSHING POSITION ADJUSTMENT]
Revised 1
5. CUTTING QUALITY CHECK
TOOL CARRIAGE ASSY
CROP MARK SENSOR
PINCH ROLLER SENSOR
3-64
TOOL CARRIAGE BOARD STAY
SCREW
TOOL CARRIAGE BOARD
SCREW
SOLENOID