4-14 BELT TENSION ADJUSTMENT
Connect the Tool Carriage to the Head Carriage and move
1
them to the right in the lock position.
Remove the Covers in order.
2
1. I/S Cover
2. Maintenance Cover
3. Left Cover
4. Front Cover
5. Top Cover
[VP-540]
3
Measure the tension of the belt at the
position above the center of the 4th Grit
Roller from the left using Tension Gauge
(ST-001)(*1).
Pull up the belt until its inside comes to
the top surface of the Cable Guide when
you see it from the machine front(*2). The
tension is proper if the measured value is
0.82kgf to 0.90kgf.
If the tension is improper, move on to the
next step and adjust the belt tension.
(Referential Time : 20min.)
LEFT
COVER
MAINTENANCE
COVER
FRONT COVER
<*1>
<*2>
4-53
Click!
TOP COVER
I/S COVER
BELT
CABLE GUIDE