Wire Tension Adjustment - Roland Color Camm Pro PC-60 Service Notes

4-17 WIRE TENSION ADJUSTMENT

WIRE TENSION ADJUSTMENT is designed to ensure the movement of the TOOL CARRIAGE and
HEAD CARRIAGE by adding the proper tension to the WIRE.
This adjustment must be performed after replacement of the WIRE and Y PULLEY.
Remove the RAIL COVER and LEFT SIDE COVER.
1
Then, move the TOOL CARRIAGE to the left end of the
machine.
Loosen the SCREW A located at the left end of the machine.
2
Measure the TENSION at the center of the machine with
3
TENSION METER (ST-011).
SCREW A
ST-011
REAR
4 Adjustment
4
TENSION
METER
SIDE
75