Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
When you specify a value for
VLAN Admin
Mode
15.2.2 show ip igmp mrouter interface
This command displays information about statically configured ports.
Format
Mode
Interface
Multicast Router
Attached
VLAN ID
15.2.3 show ip igmp mrouter vlan
This command displays information about statically configured ports.
Format
Mode
Interface
VLAN ID
15.2.4 show mac-address-table igmpsnooping
This command displays the IGMP Snooping entries in the MFDB table.
Format
Mode
MAC Address
15-8
, the following additional information appears:
vlanid
<
>
Indicates whether IGMP Snooping is active on the VLAN.
show ip igmp mrouter interface <unit/slot/port>
Privileged EXEC
Shows the port on which multicast router information is
being displayed.
Indicates whether multicast router is statically enabled on the
interface.
Displays the list of VLANs of which the interface is a mem-
ber.
show ip igmp mrouter vlan <unit/slot/port>
Privileged EXEC
Shows the port on which multicast router information is
being displayed.
Displays the list of VLANs of which the interface is a mem-
ber.
show mac-address-table igmpsnooping
Privileged EXEC
A multicast MAC address for which the switch has forward-
ing or filtering information. The format is two-digit hexadec-
imal numbers that are separated by colons, for example
01:23:45:67:89:AB. In an IVL system the MAC address is
v4.1, October 2008
IGMP Snooping Commands