Updating The Qcmc Image; Erasing The Qcmc Image - Printronix t8000 Administrator's Manual

IMPORTANT:
When the copy is completed and the printer reboots, the user should run
auto-calibration to make sure the configuration changes are used in the
calibration process.

Updating the QCMC Image

This option should only be used when a QCMC image has previously been stored from the target printer. If
some configuration settings have been altered from that point, the menu System > SD File Edit > QCMC
Update can be used to update the configuration settings in the image stored on the QCMC.
Below is a list of items that will be updated on the QCMC by the QCMC Update operation:
•
Custom configurations (1–8)
•
All variable settings from the printer's NVRAM
•
Network settings including IP Address
Below is a list of items that will NOT be updated on the QCMC by the QCMC Update operation:
•
Printer Program File (software)
•
Feature files or CST's that have been downloaded on the printer.
•
Other user files, such as fonts, bitmaps, or graphics files downloaded to the printer.
While the printer is updating the QCMC configuration, the following message will display.
WARNING
During this process, do not turn off the power.
Upon successful completion of saving a flash image to the QCMC, the printer will display a message
indicating the operation is complete. The printer will then reboot into normal operation.

Erasing the QCMC Image

This option should only be used when a QCMC has already been stored and when the user desires to start
fresh with a new image.
To utilize this option, navigate to the menu System > SD File Edit > QCMC Erase and press the ENTER
key. When this option is activated, all QCMC files and configurations will be deleted from the SD card.
While the printer is erasing the QCMC configuration, the following message will display. This could take
several minutes.
312