Printronix t8000 Administrator's Manual page 272

Displayed Message
Speed Exceeds Validator
Limit
Unscannable:
xx Missing Codes
Validator not communicating
272
Table 13. LCD Message Troubleshooting
The Print Speed or Slew Speed value is above 6 IPS as the
power-up default with the validator option installed, or the
user attempted to increase Print Speed or Slew Speed
above 6 IPS.
1. Change the Media > Speed > Print Speed or Slew
Speed to 6 IPS or less when using the Validator
option, and save the new value as the power-up
default.
Data validation error: missing barcode.
1. Check the paper and ribbon for cleanliness, wrinkles,
etc., or an obstructed validator beam. If there is no
validator beam at all, or if the LED is not flashing as
barcodes pass through the validator beam, recycle
validator power. If the problem persists, contact your
service representative.
NOTE:
xx represents the number of missing barcodes (on
the form) that caused the warning/fault to be declared.
The Validator > Control > Validator Active = Enable, but
when the printer was first powered up it could not
communicate with the validator.
1. Check that the validator signal cable is securely
connected to the validator unit.
Solution/Explanation