Printronix t8000 Administrator's Manual page 182

Determines when the Busy signal is asserted.
Disable
Enable
Factory Default
Specifies whether the data is read on the leading or trailing edge of the data
strobe signal.
Leading
Trailing
Factory Default
Specifies how data is handled when the printer is OFFLINE.
Disable
Enable
Factory Default
When a fault condition occurs in the printer, normally only the active port
reports the fault to the host. With this menu item enabled, this port will report
any fault even when it is not the current, active port. This submenu is only
available when Host IO > Control > Interface is set to Auto Switching.
Disable
Enable
Factory Default
182
Host IO > Centronics > Busy on Strobe
Asserts a busy signal only when the print buffers are
full.
Asserts a busy signal after each character is received.
Enable
Host IO > Centronics > Latch Data On
Leading Edge
Trailing Edge
Leading
Host IO > Centronics > Offline Process
When set to disable, the printer does not process data
from the Centronics port while OFFLINE.
When set to enable, the printer continues to process
(but not print) the current job from the Centronics port
while the printer is OFFLINE until the printer's buffer is
full.
Disable
Host IO > Centronics > Report Status
Will not report the fault unless the active host.
Will report the fault even if not the active host.
Disable