Printronix t8000 Administrator's Manual page 153

Application > LP+ Setup > Form Width (xx)
Specifies form width in three different units for all preferences of the user:
inches, millimeters, and even characters.
Minimum 0.1 inches
T8x04: 4.1 inches
Maximum T8x06: 6.6 inches
T8x08: 8.5 inches
Factory Default The maximum printing width based on model.
Only characters are available when the TN5250 is
IMPORTANT
enabled.
The width should not exceed the actual paper
WARNING
width to prevent damage to the platen.
Application > LP+ Setup > Left Margin
Set in characters. Character zero is defined as the far left edge of the page,
and column numbering increments from left to right.
Minimum 0 characters
Maximum 369 characters
Factory Default 0 characters
IMPORTANT This menu is hidden when TN5250 is enabled.
Application > LP+ Setup > Right Margin
Set in characters. Character zero is defined as the far right edge of the page,
and column numbering increments from right to left.
Minimum 0 characters
Maximum 369 characters
Factory Default 0 characters
IMPORTANT This menu is hidden when TN5250 is enabled.
153