Printronix t8000 Administrator's Manual page 225

Figure 10 Setting Printer Properties Sharing Options
5. Start a Windows Command Prompt session.
6. Navigate to the directory with the target firmware (e.g., c:\download).
7. Execute FILENAME.exe as follows:
WARNING
DO NOT interrupt the downloading process once it has started. Interrupting a
download will leave the flash memory on the controller PCBA incompletely
loaded, and the printer may not boot up.
8. When the new software has successfully loaded into flash memory and the printer has reset
itself, the process is complete.
Connection Type
Parallel
Serial
USB
Ethernet
Enter Command
FILENAME –a -pb <Enter>
mode COM1:9600,N,8,1 <Enter>
mode LPT1=COM1 <Enter>
FILENAME –a -pb <Enter>
FILENAME –a –pbSharedName <Enter>
where SharedName of the printer is the 'Share
name' entered during installation.
FILENAME -n xxx.xxx.xxx.xxx <Enter>
where xxx.xxx.xxx.xxx represents the IP address.
225