Tools > Diagnostics - Printronix t8000 Administrator's Manual

This item selects the number of times the selected test pattern will be
printed.
Continuous
Selections
Factory Default
Tools > Diagnostics
This executable menu prints the current log of errors. Most non-routine faults
(RIBBON FAULT, PRINT HEAD HOT) are stored in the error log.
This executable menu clears the error log.
This turns on the hex dump diagnostic. See Chapter 6 Diagnostics and
Troubleshooting page 243 for more information.
Disable
Enable
Factory Default
IMPORTANT
214
Tools > Print Tests > Test Count
Print continuously until the user stops the test by
printing the ENTER key.
Choose among 1 Page, 2 Pages, 5 Pages, or 10
Pages.
Continuous
Tools > Diagnostics > Print Error Log
Tools > Diagnostics > Clear Error Log
Tools > Diagnostics > Hex Dump Mode
Hex dump mode is turned off.
Hex dump mode is turned on and all incoming data will
be printed in hexadecimal format.
Disable
If the IPDS option is installed and IPDS (by default)
is active, then enabling Hex Dump might not be
possible. In this case, the user will be alerted via
an LCD warning.