Application > Vgl Setup - Printronix t8000 Administrator's Manual

Allows the user to map the parameter DISK to either EMC (SD card) or
FLASH memory.
Disk=SD
Disk=PCB
Flash
Factory Default
Application > VGL Setup
IMPORTANT
The VGL Setup submenu will only be present when the Active IGP Emulation is
set to VGL. Otherwise, this menu will be replaced with the Active IGP Emulation
Setup menu.
This option selects the Special Function Control Code. Run a configuration
printout to determine the currently selected SFCC.
Minimum
Maximum
Factory Default
Determines if VGL is active at power-up or if all the data will be passed down
to the LP+ emulation for processing.
Disable
Enable
Factory Default
136
Application > PGL Setup > Storage Select
Have the DISK command default to the SD card.
Have the DISK command default to the FLASH
memory.
Disk=EMC
Application > VGL Setup > Select SFCC
17
255
caret ^ (decimal 94)
Application > VGL Setup > Power-up ^X
VGL is ready to process data.
VGL starts in ignore mode. The graphics mode ^PY is
set as the power-up default. All characters are ignored
until a ^A command is received.
Disable