System > Energy Star; System > Flash File View; System > Flash File Edit - Printronix t8000 Administrator's Manual

System > Energy Star
The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode. When you enter into Power
Saver mode, the panel backlight is dimmed, the engine shuts down, and a panel
message informs the user.
Pressing any Control Panel key or certain network access to the printer removes
the Power Saver message from the panel and the turns on the backlight (but the
engine is still shut down). Sending a print job to the printer results in a full exit of
Power Saver mode.
Selections
Factory Default
IMPORTANT
This menu allows you to enable and disable Power Saver mode. If enabled,
the menu for Power Saver Time is in effect.
Disable
Enable
Factory Default
System > Flash File View
This subsection will show all font and user downloaded files in FLASH memory. Files with one of the
filename extensions Filename Extensions Not Shown in Menus page 230 are not shown in this section.
The name of the file will be shown along with its size in bytes. This is a read-only section.
System > Flash File Edit
This subsection can be used to configure how FLASH file storage can be used and allow the users to
delete files, copy files to the SD card, optimize memory, etc.
System > Energy Star > Pwr Saver Time
The options are 1, 5, 10, 15, 30, 45, 60, and 240
minutes.
5 minutes.
When ODV is installed and enabled, about 20
seconds is required to re-initialize ODV. During the
Power Saver exiting procedure, a message will be
displayed alerting user of the required delay.
System > Energy Star > Pwr Saver Active
Power Saver mode is disabled and not used.
Power Saver mode is enabled.
Enable
97