Printronix t8000 Administrator's Manual page 242

Figure 18 Inserting The SPX into the Debug Port
4. Power on the printer. The printer will begin its boot-up sequence.
5. When the printer detects a valid SPX, the control panel displays:
"NEW SPX DETECTED
PRESS ENTER"
NOTE:
If an error message displays, find the message in the Message List in Chapter 6 page 243 and
follow the troubleshooting instructions.
6. Press the ENTER key to activate the reprogramming sequence. The display will read:
PROGRAMMING. PLEASE WAIT."
7. When the security key is reprogrammed, the display will read:
"UPGRADED - REMOVE SPX
Downld code if needed"
8. Remove the SPX from the debug port at the rear of the printer.
9. Press the ENTER key. The printer will reboot automatically and you may resume normal printing.
10. You may need to download a new program file to use the new feature.
11. You may need to set additional menu parameters for any new features that have been added or
enabled.
242