Printronix t8000 Administrator's Manual page 265

Table 13. LCD Message Troubleshooting
Displayed Message
LABEL MISSING
Check Paper Path
Solution/Explanation
The Label Taken Sensor did not detect the label present over
the tear bar with Tear-Off or Peel-Off Media Handling mode
enabled.
•
The label was removed before the printer stopped
printing or before the LCD "Remove Label" message
displayed.
•
The label slipped behind the platen roller.
•
The label wrapped around the platen roller.
•
Tear-Off or Peel-Off Media Handling mode was
mistakenly selected.
1. Press the PAUSE key to continue printing and then wait
for the LCD "Remove Label" message before removing
the label.
2. Open the pivoting deck, reinstall the label, close the
deck, press the PAUSE key, and continue printing.
3. Open the pivoting deck and remove wrapped labels from
the platen. Clean all adhesive from the platen. Reinstall
labels, close the deck, press the PAUSE key, and
continue printing.
4. Select the correct Media Handling mode in the Media
> Handling section.
265