Configs > Custom; Tools; Tools > Print Tests - Printronix t8000 Administrator's Manual

Configs > Custom
Configs > Custom > Name Config 1 ... Name Config 8
Using the virtual keyboard of the UI, you may specify a 15-character name
which can be used to refer to a configuration. The name you enter for a
configuration will be used in the Load Config, Save Config, Print Config,
Delete Config, and Power-Up Config menus. The names can only be
cleared by using the Reset Cfg Names menu.
String
Factory Default
You can reset specific configuration names back to the default value of the
configuration number.
All
1-8
Factory Default

Tools

Tools > Print Tests
The printer tests below allow you to check for proper printer operation and
print quality. Once you have selected the desired test, press the ENTER key
to start printing. If the Test Count option (below) is set to Continuous, press
ENTER key again to stop printing.
Auto Calibrate
Checkerboard
Grey
Grid
212
Any 15-character string using UI keyboard.
Config 1 ... Config 8
Configs > Custom > Reset Cfg Names
Reset all custom configuration names.
Reset a specific custom configuration name.
1
Tools > Print Tests > Run Tests
Senses paper out, perforation, gap, or mark, and
calibrates the printer for the currently installed media.
This pattern helps identify marginal printhead
elements, quality of edge sharpness, and uneven print
quality.
This pattern helps identify burned out printhead
elements and uneven print quality.
This pattern helps identify edge sharpness and uneven
print quality.