Network > Wlan - Printronix t8000 Administrator's Manual

You can enable/disable the BootP protocol using this option, but consult
your administrator for the appropriate setting.
Disable
Enable
Factory Default
IMPORTANT
This menu appears only if a 10/100Base-T Network Interface Card (NIC) is
installed.The Ethernet Speed menu has five different speed modes to allow
compatibility with different systems and networks.
Auto Select
10 Half Duplex
10 Full Duplex
100 Half Duplex
100 Full Duplex
Factory Default
Network > WLAN
198
Network > Ethernet > BootP
BootP is disabled.
BootP is enabled.
Disable
If changed, the printer reboots when it is placed
ONLINE.
Network > Ethernet > Ethernet Speed
Tells the 10/100Base-T NIC to perform an auto
detection scheme and configure itself to be 10 Half
Duplex, 10 Full Duplex, 100 Half Duplex, or 100 Full
Duplex.
Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using half duplex.
Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using full duplex.
Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using half duplex.
Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using full duplex.
Auto Select