Printronix t8000 Administrator's Manual page 302

Command
CONFIG
LP MODE
302
Table 27. General PTX_SETUP Commands
Sub-Command
PNE_PORT
PANEL
PNE_PORT_NUM
PXML_PORT_NUM
n/a
Parameter
Port This command selects the port that
the PNE will use to communicate to
the printer.
The valid ports are:
•
•
•
•
NOTE:
but not enabled, the selection will
revert to DISABLE.
LOCK This command locks the operator
out of the printer's configuration
menu.
UNLOCK This command unlocks the printer's
configuration menu and allows the
operator access to the menus. By
default, the menu is unlocked.
Port Number This command sets the Port
Number the PNE uses to
communicate to the printer if the
PNE Port was set to Ethernet. This
command causes the printer to
automatically reboot.
Port Number This command sets the Port
Number the PXML and UCP will use
to communicate to the printer if the
PXML Port is set to Ethernet. This
command causes the printer to
automatically reboot.
Protocol must be 0-4. This
Protocol
command resets the software
protocol, and is selected as follows:
0 - P-Series
1 - P-Series XQ
2 - Serial Matrix
3 - Proprinter III XL
4 - Epson FX-1050
Description
DISABLE
ETHERNET
USB
If ETHERNET is selected