Printronix t8000 Administrator's Manual page 270

Displayed Message
PRINTER HOT
PRINTER UNDER
REMOTE CONTROL
PROGRAMMING 1284
OPTION CARD
---------------------
DO NOT POWER OFF
PROGRAMMING GPIO
OPTION CARD
---------------------
DO NOT POWER OFF
P/S MISMATCH
Replace Supply
PWR SUPPLY HOT
RBN TAKEUP FULL
Remove Used Rbn
270
Table 13. LCD Message Troubleshooting
The printer has detected higher than usual temperatures on
the controller PCBA.
1. Determine that the fan is operating and that all air
vents are unobstructed.
2. Power off the printer for 15 seconds, then power the
printer back on.
3. Move the printer to a cooler location.
4. If the problem persists after moving the printer to a
cooler location, contact your authorized customer
service representative.
Indicates that PNE has control of the printer.
1. Press any key on the printer.
Status Message indicating that the IEEE1284 option card
FPGA is being programmed. This process will take less than
60 seconds to complete and a message will be displayed
when completed.
Status Message indicating that the GPIO option card FPGA
is being programmed. This process will take less than 30
seconds to complete and a message will be displayed when
completed.
Incorrect power supply is mounted in the printer.
1. Contact your authorized customer service
representative.
Power supply is hot.
1. Determine that the fan is operating and that all air
vents are unobstructed.
2. Move the printer to a cooler area.
3. If the problem persists, contact your authorized
customer service representative.
The ribbon takeup spool is full.
1. Empty the takeup spool.
2. If the takeup spool is not full, try re-threading the
ribbon.
3. Disable Media > Ribbon > Takeup Full.
Solution/Explanation