System > Gpio - Printronix t8000 Administrator's Manual

This menu selects the port number the printer expects the PXML or UCP to
connect through.
Minimum
Maximum
Factory Default
Since PXML and UCP management protocols share the same Ethernet port,
only one can be active at a time. This menu selects the active Management
Protocol Interface, either PXML or UCP.
PXML
UCP
Factory Default
System > GPIO
GPIO (General Purpose I/O) is both hardware and software. The hardware is the actual IO board mounted
in the printer, and the software is the GPIO Manager which is part of PNE (PrintNet Enterprise). The GPIO
hardware is a printed circuit board containing optically isolated inputs and outputs as well as relays. The
GPIO software is both a printer resident GPIO event parser that executes GPIO Tables created by the GPIO
Manager. The GPIO table is used to control how the GPIO hardware behaves for a given application.
Refer to the GPIO User's Guide for more information and a description of the menus in this section.
IMPORTANT
This subsection will only be visible when the GPIO option installed.
System > Printer Mgmt > Mgmt Port Number
1025
65535
3007
System > Printer Mgmt > Mgmt Protocol
Printronix XML management protocol used to control
and manage the printer. See the XML Programmer
Reference Guide for more information.
The Universal Control Port that can be used for GPIO
or CST applications.
PXML
103