Changing the Printer Settings
This section explains the basic procedure to change the equipment settings.
•
Administrator Setup Menu
•
Other Setup Menu
•
Print Statistics
•
Boot Menu
•
Setup the Buzzer
•
Hiding the paper size confirmation message
•
If a Power Failure Occurs
Administrator Setup Menu
This section describes how to change the settings of the printer as an Administrator.
1
Press the scroll button
press the «ENTER» button.
2
Enter the administrator password using the numeric (0-9) keys, and then press
the «ENTER» button.
The factory default password is "123456".
3
Press the scroll button
to change a setting and then press the «ENTER» button.
4
Press the scroll button
5
Press the «ENTER» button.
6
Press the «ON LINE» button to exit the menu mode.
• Network Setup
Item
Factory Default
Enabling Default Gateway
Wired
(When Wireless LAN is installed)
Wired
Enable
TCP/IP
Enable
NetBIOS over TCP
Enable
IP Address Set
Auto
IPv4 Address
***.***.***.***
Subnet Mask
***.***.***.***
Gateway Address
***.***.***.***
DHCPv6
Disable
Web
Enable
Telnet
Disable
FTP
Disable
- 79 -
5. Management / Setting the Printer
several times to select [Admin Setup] and then
or
to select the setup menu on which you want
or
to change the setting.
Description
Selects a connecting method between different
segments.
Sets whether to enable wired LAN.
Sets whether to enable TCP/IP.
Sets whether to enable NetBIOS over TCP.
Sets the setting method of IP address.
Sets the IP address. This item is displayed when [IP
Address Set] is [Manual].
Sets the Subnet Mask. This item is displayed when [IP
Address Set] is [Manual].
Sets the Gateway Address. This item is displayed when
[IP Address Set] is [Manual].
Selects enable / disable of DHCP when IPv6 is used.
Enables/disables to access to the web page of the
printer.
Sets whether to enable Telnet.
Sets whether to enable FTP.