To Remove The Ei Hes Radiator - Agilent Technologies 5977B Series Operating Manual

7 CI Maintenance

To Remove the EI HES Radiator

Materials needed
• Gloves, clean, lint-free
• Tweezers (8710-2460)
• T10 Torx screwdriver (5182-3466)


Procedure
The analyzers, GC/MS interface, and other components in the analyzer chamber
WA R N I N G
operate at very high temperatures. Do not touch any part until you are sure it is cool.
• Always wear clean gloves to prevent contamination when working in the analyzer
C A U T I O N
• Make sure you use an antistatic wrist strap and take other antistatic precautions
• When disconnecting leads, pull on the connectors, not on the wires
1
2
3
200
• Large (8650-0030)
• Small (8650-0029)
chamber.
before touching analyzer components.
Remove the EI HES. (See
Disconnect the wires from the EI HES radiator. (See
Connect/Disconnect Wiring to the EI HES Radiator"
Use a T10 Torx screwdriver to loosen the 2 screws that secure the radiator
to the analyzer, and place the radiator in its storage container.
"To Remove the EI HES"
5977B Series MSD Operating Manual

on page 154.)
"To
on page 201.)