To Remove The Detector Top Cover - Agilent Technologies Agilent 7890 Series Maintenance Manual

2
Removing Covers

To Remove the Detector Top Cover

C A U T I O N
18
This cover protects the detectors, valve box, and valve
assembly. To remove the detector top cover:
Raise it to a vertical position
1
Lift the right side and disengage the pin on the lower left
2
side.
Do not force the cover, either when installing it or closing it. This
could break the plastic parts.
To replace the cover, make certain that the slot in the
bushing (lower right corner) is vertical and that the bushing
is fully seated. Installation is then the reverse of removal.
Maintaining Your GC