Motorola WiNG 5.7.1 System Reference Manual page 502

6 - 32 WiNG 5.7.1 Access Point System Reference Guide
14. Click the icon within the
add criteria into the configuration of the IPv6 ACL.
Figure 6-16 WLAN Security - IPv6 Firewall Rules - IPv6 Firewall Rules Add Criteria screen
15. Define the following parameters for either inbound or outbound IPv6 firewall rules:
Precedence
Allow
Source
Figure 6-15 WLAN Security - IPv6 Firewall Rules - Edit Rule screen
Description column (top right-hand side of the screen) and select IPv6 filter values as needed to
Specify or modify a precedence for this IPv6 policy between 1-1500. Rules with lower
precedence are always applied to packets first. If modifying a precedence to apply a
higher integer, it will move down the table to reflect its lower priority.
The Precedence column sets the priority of a IPv6 Firewall rule within its rule set.
Every IPv6 firewall rule is made up of matching criteria rules. The action defines what to
do with the packet if it matches the specified criteria. The following actions are
supported:
• Deny - Instructs the firewall to prohibit a packet from proceeding to its destination.
• Allow - Instructs the firewall to allow a packet to proceed to its destination.
Select the source IPv6 address or network group configuration used as a basis matching
criteria for this IPv6 ACL rule. Source options include:
• Any – Indicates any host device in any network.
• Network – Indicates all hosts in a particular IPv6 network. Subnet mask information
has to be provided for filtering based on network.
• Host – Indicates a single host with a specific IPv6 address.