Motorola WiNG 5.7.1 System Reference Manual page 450

5 - 366 WiNG 5.7.1 Access Point System Reference Guide
Refer to the following for more information on the Path Method SNR screen. These descriptions apply to both the 2.4 GHz
and 5.0/4.9 GHz frequencies.
Channel Width
Priority Meshpoint
SNR Delta
Figure 5-247 Mesh Point Auto Channel Selection Path Method SNR screen
Configure the channel width that mesh point automatic channel scan should assign to the
selected radio. The available options are:
• Automatic – Indicates the channel width is calculated automatically. This is the
default value.
• 20 MHz – Indicates the width between two adjacent channels is 20 MHz.
• 40 MHz – Indicates the width between two adjacent channels is 40 MHz.
• 80 MHz – Indicates the width between tow adjacent channels is 80 MHz. This is only
available on access points that support 802.11ac.
Configure the mesh point to be monitored for automatic channel scan. This is the mesh
point that given priority over other available mesh points. When configured, a mesh is
created with this mesh point. When not configured, a mesh point is automatically
selected.
Configure the signal to noise ratio delta value for path selection.
When path selection occurs, this set value is considered for selecting the optimal path.
A better candidate on a different channel must have a signal strength that exceeds this
delta value when compared to the signal strength of the next hop in the mesh network.
The default is 5dB