Motorola WiNG 5.7.1 System Reference Manual page 430

5 - 346 WiNG 5.7.1 Access Point System Reference Guide
7. Select the ACL
Create icon, or an existing set of IP ACL rules can be modified by selecting the
8. Use the spinner to select the
Dynamic NAT policy rule.
9. Use the IP Address Range
Interface
NAT Pool
Overload IP
Overload Type
10. Select + Add Row
Figure 5-232 Profile Security - Dynamic NAT screen
whose IP rules are applied to this policy based forwarding rule. A new ACL can be defined by selecting the
ACL Precedence. The lower the precedence value, the higher the priority assigned to this
table to configure IP addresses and address ranges that can used to access the Internet.
Lists the outgoing layer 3 interface on which traffic is re-directed. The interface can be an
access point WWAN or PPPoE interface. Traffic can also be redirected to a designated
VLAN.
Displays the NAT pool used by this Bridge NAT entry. A value is only displayed only when
Overload Type has been set to NAT Pool.
Lists the IP address used to represent a large number local addresses for this
configuration.
Displays the override type for this policy based forwarding rule.
to set the IP address range settings for the Bridge NAT configuration.
Edit icon.