Motorola WiNG 5.7.1 System Reference Manual page 858

13 - 42 WiNG 5.7.1 Access Point System Reference Guide
Mobility
Metric
State
Binding
Timeout
Sequence
The Root tab displays the following:
Mesh Point Name
Recommended
Root MPID
Next Hop IFID
Radio Interface
Bound
Metric
Interface Bias
Neighbor Bias
Root Bias
The Multicast Path
Mesh Point Name
Subscriber Name
Subscriber MPID
Group Address
Displays whether the mesh point is a mobile or static node. Displays True when the device
is mobile and False when the device is not mobile.
A measure of the quality of the path. A lower value indicates a better path.
Indicates whether the path is currently Valid of Invalid.
Indicates whether the path is bound or unbound.
The timeout interval in seconds. The interpretation this value will vary depending on the
value of state. If the state is Init or In Progress, the timeout duration has no significance.
If the state is Enabled, the timeout duration indicates the amount of time left before the
security validity check is initiated. If the state is Failed, the timeout duration is the amount
of time after which the system will retry.
The sequence number also known as the destination sequence number. It is updated
whenever a mesh point receives new information about the sequence number from RREQ,
RREP, or RERR messages that may be received related to that destination.
Displays the name of each configured mesh point in the RF Domain.
Displays the root that is recommended by the mesh routing layer.
The MP identifier is used to distinguish between other mesh points both on the same
device and on other devices. This is used by a user to setup the preferred root
configuration.
The IFID of the next hop. The IFID is the MAC address on the destination device.
This indicates the interface that is used by the device to communicate with this neighbor.
The values are 2.4 and 5.0, indicating the frequency of the radio that is used to
communicate with the neighbor.
Indicates whether the root is bound or unbound.
Displays the computed path metric between the neighbor and their root mesh point.
This field lists any bias applied because of preferred root Interface Index.
This field lists any bias applied because of preferred root next-hop Neighbor IFID.
This field lists any bias applied because of preferred root MPID.
tab displays the following:
Displays the name of each configured mesh point in the RF Domain.
Lists the subscriber name is used to distinguish between other mesh point neighbors both
on the same device and on other devices.
Lists the subscriber ID to distinguish between other mesh point neighbors both on the
same device and on other devices.
Displays the MAC address used for the group in the mesh point.