Motorola WiNG 5.7.1 System Reference Manual page 449

This screen provides configuration for the 2.4 GHz and 5.0/4.9 GHz frequencies. Refer to the following for more information
on the Auto Channel Selection Dynamic Root Selection screen. These descriptions are common for configuring the 2.4 GHZ
and 5.0/4.9 GHz frequencies
Channel Width
Priority Meshpoint
Off Channel Duration
Off Channel Scan
Frequency
Meshpoint Root - Sample
Count
Meshpoint Root - Channel
Hold Time
9. Select the Path Method SNR
Configure the channel width that mesh point automatic channel scan should assign to the
selected radio. The available options are:
• Automatic – Indicates the channel width is calculated automatically. This is the
default value.
• 20 MHz – Indicates the width between two adjacent channels is 20 MHz.
• 40 MHz – Indicates the width between two adjacent channels is 40 MHz.
• 80 MHz – Indicates the width between tow adjacent channels is 80 MHz. This is only
available on access points that support 802.11ac.
Configure the mesh point to be monitored for automatic channel scan. This is the mesh
point that given priority over other available mesh points. When configured, a mesh is
created with this mesh point. When not configured, a mesh point is automatically
selected.
Configure the duration in the range of 20 - 250 milliseconds for the Off Channel Duration
field. This is the duration that the scan dwells on each channel when performing an off
channel scan.
Configure the time duration in seconds between two consecutive Off Channel Scans. Set
a duration between 1 - 60 seconds.
Configure the number of scans to be performed for data collection before a mesh channel
is selected. Set a value between 1 - 10 scans.
Configure the minimum duration to stay on a selected channel before the channel
conditions are reassessed for a possible channel change. Set a value between 0 - 1440
minutes. Set this value to 'Zero' (0) to prevent a automatic channel selection from
happening.
tab to configure the signal to noise ratio when selecting the path to the mesh point root.
5 - 365