Motorola WiNG 5.7.1 System Reference Manual page 566

6 - 96 WiNG 5.7.1 Access Point System Reference Guide
9. Refer to the Select Authentication
Security Mode
10. Set the following
Pre-Shared Key
11. Set the following
Unicast Rotation Interval
Broadcast Rotation
Interval
12. Select OK to save the changes made to the configuration. Select
13. Set the following
User ID
Figure 6-44 MeshConnex - Security screen
field to define an authentication method for the mesh policy.
Select a security authentication mode for the mesh point. Select None to have no
authentication for the mesh point. Select PSK to set a pre-shared key as the
authentication for the mesh-point. If PSK is selected, enter a pre-shared key in the Key
Settings field. The default setting is None.
Key Settings for the mesh point:
When the security mode is set as PSK, enter a 64 character HEX or an 8-63 ASCII character
passphrase used for authentication on the mesh point.
Key Rotation for the mesh point:
Define an interval for unicast key transmission in seconds (30 - 86,400). This option is
disabled by default.
When enabled, the key indices used for encrypting/decrypting broadcast traffic will be
alternatively rotated based on the defined interval. Define an interval for broadcast key
transmission in seconds (30 - 86,400). Key rotation enhances the broadcast traffic security
on the WLAN. This option is disabled by default.
EAP PEAP Authentication
Configure the user name for PEAP MSCHAPv2 authentication.
Reset to revert to the last saved configuration.
information for the mesh point: