Motorola WiNG 5.7.1 System Reference Manual page 455

6. Use the Group ID field to define a group ID of up to 32 characters.
7. Use the drop-down to set a value for
The default value is Prefer 5GHz.
8. Refer to the following Neighbor Selection Strategies
Using probes from
common clients
Using notifications from
roamed clients
Using smart-rf neighbor
detection
9. Select Balance Band Loads by Ratio
10. Refer to the following Channel Load Balancing
Balance 2.4 GHz Channel
Loads
Figure 5-249 Device Overrides - Client Load Balancing
SBC strategy. Options include Prefer 5GHz, Prefer 2.4 GHz, and distribute-by-ratio.
Select this option to enable neighbor selection using probe requests from common
clients between the neighbor device and this device.
Select this option to enable neighbor selection using notifications from clients roamed
from other devices.
Select this option to enable neighbor selection using Smart RF neighbor detection
algorithm.
to configure or override
fields to configure or override it:
Select this option to balance the access point's 2.4GHz radio load across the channels
supported within the country of deployment. This can prevent congestion on the 2.4GHz
radio if a channel is over utilized.
fields to configure or override it:
Band Load Balancing
5 - 371
configuration.