Test Print Mode - SATO S84ex Operator's Manual

4 Operation and Configuration

4.2.17 Test Print Mode

The flowchart shows the sequence of the setting screens for the test print mode. The table describes
each setting screen in detail.
* Press the , ,
select an item or set the value
accordingly. The active arrow icons
are shown on the screen.
* Pressing the button on each
screen will revert to the TEST
PRINT MODE menu.
Note
• When EXTERNAL SIGNAL in the ADVANCED MODE menu is set to ENABLE, the printer is unable to
perform the test print correctly.
Make sure that the EXTERNAL SIGNAL is set to DISABLE before perform test print.
• When RFID mode is enabled, RFID related information is printed on the second page of the
CONFIGURATION test print.
178
S84-ex/S86-ex Operator Manual
or button to
When the above TEST
PRINT MODE is set as
CONFIGURATION,
BARCODE or HEAD CHECK.
button
button
Press button
+ Power On
button
button
When the above TEST
PRINT MODE is set as
FACTORY or WLAN.
button
or
or
button
button
or button
button
Test print
WLAN shows only when a
wireless LAN unit is installed.
When the above TEST
When the
PRINT MODE is set as above
CONFIGURE LIST.
TEST
PRINT
MODE is
set as
FONT or
MEMORY
button