SATO S84ex Operator's Manual page 233

ROTATE LABEL
Set the rotation for printing.
• 0: Print the media as usual without rotation.
• 180: Print the media with 180 degree rotation.
SIZE MODE
Set the label size adjustment control.
• CMD: The label size is set by command.
• AUTO: The label size is measured automatically by the printer.
• LCD: The label size is set by the following screen.
Note
When AUTO is selected, the printer will automatically feed two blank labels to check the label size. The
printer will perform the checking function when SZPL emulation mode active in the following scenarios:
• Printer power on (Initial feed setting must be enabled in Service mode).
• After head open error clearance.
• When switching from SBPL mode to SZPL emulation mode.
• When change the size mode to AUTO from other mode.
If AUTO ONLINE FEED under Service mode is set to NO, SIZE MODE will switch to CMD automatically.
The label size setting will be override by the Label Width ^PW or Label Length ^LL Zebra command if it is
specify within the data stream regardless of the current Size Mode setting (for example AUTO/LCD).
LABEL SIZE ADJ WIDTH
Set the width of the media.
The setting range varies depending on the following model:
Model
S84-ex (203 dpi)
S84-ex (305 dpi)
S84-ex (609 dpi)
S86-ex (203 dpi)
S86-ex (305 dpi)
Note
Shows only if SIZE MODE is set to LCD.
Setting Range (dot)
0000 to 0832
0000 to 1248
0000 to 2496
0000 to 1340
0000 to 2010
5 Emulation Mode
S84-ex/S86-ex Operator Manual 231