SATO S84ex Operator's Manual page 131

CALENDAR REPRINT
Perform the calendar reprint setting.
• YES: The updated calendar data (date and time) according to the RTC
(Real Time Clock) is included in the reprint data.
• NO: Print exactly the same data as before.
Note
Shows only if EXTERNAL REPRINT is set to ENABLE, REPRINT W/
FEED is set to YES, FUNCTION KEY is set to REPRINT, or
CONTINUOUS PRINT is set to ENABLE.
FORWARD/BACKFEED DISTANCE
Set the feed length in the forward and backward directions.
• DEFAULT: Enable the printer to operate using the fixed value
maintained in the printer.
• 000mm: Set the feed length to enable the printer to operate using this
distance. The setting range of forward/backward feed length is from
001 mm to 255 mm (0.04" to 10").
The actual forward/backward feed length is equivalent to the offset
adjustment value + the paper feed length.
Note
• If using thermal transfer for printing, set the feed distance to less than
30 mm (1.2") to avoid detection of the ribbon end by mistake.
• If the value is larger than the distance between the print head and the
option stop position, the media may shift away from the platen during
backward feed.
EXT 9PIN SELECT
Set the output mode of the external signal pin 9 when using a 14-pin
connector (pin 6 when using a 25-pin connector).
• MODE1: The output signal becomes "Active" when there is remaining
print data without error in online mode.
• MODE2: The output signal becomes "Active" when the printer is
ONLINE.
Note
Refer to the Timing Chart of the EXT Output Signal (Online)
4 Operation and Configuration
for details.
S84-ex/S86-ex Operator Manual
129