SATO S84ex Operator's Manual page 68

4 Operation and Configuration
CAUTION
Be sure to perform a virus check for the USB memory or SD card before connecting it to the printer. SATO
Corporation shall not be held responsible for a malfunction of the printer caused by a virus infection through
the USB memory or SD card.
Note
It is also possible to register, recall and print a SBPL command file that is prepared in advance, as a simple
standalone data, and save it to the SD card or USB memory.
Prepare the data according to the followings:
• There should be no command errors in the SBPL command.
• The file name should be equal or less than 16 characters, and the extension should be "SSA". Refer to
below descriptions on
• The data should be saved to "(SD card/USB memory route)\PR61\DATA" folder.
STANDALONE MODE
Select the following options using
ENTER button.
• LOAD: Read and print the file.
• SAVE: Save the received print data to a file.
Note
Three beeps will sound if you select SAVE and press the
button when there is no received data.
INTERFACE SELECT
Select the memory type using the
ENTER button.
Note
• When LOAD is selected in previous screen, three beeps will sound if the
connected memory has no data to load, or the selected memory is not
connected.
• When SAVE is selected in previous screen, three beeps will sound if the
number of registered items is 99, or the selected memory is not
connected.
66
S84-ex/S86-ex Operator Manual
SET NAME screen for usable characters.
the / buttons and then press the
/
buttons and then press the
ENTER