SATO S84ex Operator's Manual page 363

Cable Specifications
Cable Connector
Cable Length
Note
• When using the READY/BUSY control, make sure that the printer is in power on mode before you send the
data from the host.
• With communication protocols such as XON/XOFF, STATUS3, STATUS4 or STATUS5, a receive buffer full
error will occur when the received data is more than the receive buffer size (2.95 MB). Send data that is less
than 2.95 MB while monitoring the status of the printer.
• A parity error will be detected if this error occurs after the reception of ESC+A.
DB-9 Male or equivalent
5 m (16.4 feet) or less
8 Appendix
S84-ex/S86-ex Operator Manual 361