SATO S84ex Operator's Manual page 344

8 Appendix
The types of errors to print are as follows:
Message
TAG NOT FOUND
WRITE TAG ERROR
VERIFY ERROR
LOCKING ERROR
MULTI TAGS ERROR
CHIP MAKER ERR.
MCS NOT SUPPORT
READ ONLY ERROR
342 S84-ex/S86-ex Operator Manual
Cause and Countermeasure
Cause Did not find the tag to print, or failed to read the tag.
Countermeasure Confirm the inlay operation and check the printer/antenna
configuration.
Cause Failed to write the tag.
Countermeasure Confirm the inlay operation and check the printer/antenna
configuration.
Cause The written value and the read value do not match.
Countermeasure Confirm the inlay operation and check the printer/antenna
configuration.
Cause Failed to lock the tag.
Countermeasure Check the media.
Cause Multiple tags captured at a time.
Countermeasure Confirm the inlay operation and check the printer/antenna
configuration.
Cause Specified tag chip manufacturer is not correct when
specifying in MCS setting and encoding SGTIN96.
Countermeasure Check the media, and correct the tag chip manufacturer.
Cause Unsupported inlay (IC chip) is used when specifying the MCS
setting and encoding SGTIN96.
Countermeasure Check the media, and change it with supported inlay.
Cause Succeeded to read but failed to write the tag.
Countermeasure Confirm the inlay operation and check the printer/antenna
configuration.