SATO S84ex Operator's Manual page 173

TAG DATA
This screen shows the data of the RFID tag.
If the read code is more than thirty-two digits, scroll using the
buttons to show the data.
If reading of the data is failed, NO TAG FOUND is shown.
• RETRY: Read the data again.
• CONTINUE: Proceed to the next screen.
ANTENNA PITCH
Set the antenna pitch.
• STANDARD
• SHORT
RFID TAG OFFSET
Set the value of the tag offset.
If the value is set to other than 0, tag writing is done during pause in
printing.
The setting range is from 0 to 240 mm.
To release this function, set the value to 0 mm.
WRITE POWER
Set the write power of the antenna, referring to the "S84-ex UHF Inlay
Placement & Configuration Table" in the S84-ex UHF RFID Configuration
Guide.
The measurement unit is in dBm, and it is adjustable with 0.1 dBm.
The value converted to milliwatts (mW) is shown on the left.
The setting range differs according to the mounted RFID module.
The setting range is from 0.0 to 24.0 dBm.
4 Operation and Configuration
/
S84-ex/S86-ex Operator Manual
171