SATO S84ex Operator's Manual page 104

4 Operation and Configuration
CHARACTER BIT
Set the RS-232C data length.
The following options are available:
• 7BIT
• 8BIT
Note
• Shows only if the RS-232C interface is selected.
• The setting will be effective only if you power on the printer again.
PROTOCOL
Set the communication protocol.
• READY/BUSY: When selected, the printer will proceed to the
RECEIVE BUFFER screen.
• XON/OFF: When selected, the printer will proceed to the RECEIVE
BUFFER screen.
• STATUS2: When selected, the printer will proceed to the IGNORE CR/
LF screen.
• STATUS3: When selected, the printer will proceed to the IGNORE CR/
LF screen.
• STATUS4: When selected, the printer will proceed to the IGNORE CR/
LF screen.
• STATUS5: When selected, the printer will proceed to the ITEM NO.
CHECK screen.
Note
The setting will be effective only if you power on the printer again.
ITEM NO. CHECK
Set the item number check function.
• ENABLE: Enable the item number check function.
• DISABLE: Disable the item number check function.
Note
Shows only if PROTOCOL is set to STATUS5.
102
S84-ex/S86-ex Operator Manual