SATO S84ex Operator's Manual page 98

4 Operation and Configuration
DHCP SETTING
Enable or disable DHCP.
• ENABLE: Enable DHCP.
• DISABLE: Disable DHCP.
Note
• Shows only if the LAN or WLAN interface is selected.
• The setting for the WLAN interface will be effective only if you power on
the printer again.
IPv4 ADDRESS
Set the IPv4 address.
The setting range is from 0.0.0.0 to 255.255.255.255.
The default value is 192.168.001.001.
Note
• Shows only if the LAN or WLAN interface is selected.
• The setting will be effective only if you power on the printer again.
IPv4 SUBNET MASK
Set the IPv4 subnet mask address.
The setting range is from 0.0.0.0 to 255.255.255.255.
The default value is 255.255.255.000.
Note
• Shows only if the LAN or WLAN interface is selected.
• The setting will be effective only if you power on the printer again.
IPv4 GATEWAY ADR
Set the IPv4 gateway address.
The setting range is from 0.0.0.0 to 255.255.255.255.
The default value is 000.000.000.000 for LAN and 192.168.001.002 for
WLAN.
Note
• Shows only if the LAN or WLAN interface is selected.
• The setting will be effective only if you power on the printer again.
96
S84-ex/S86-ex Operator Manual