SATO S84ex Operator's Manual page 338

8 Appendix
When a gap exists in the back of the label
The figure and table below show the distance (A) from the end of printing to the next print start position
with backfeed for printing. It also shows the consumption of the ribbon (B) when the ribbon saver is
operating.
Condition
(1) Print operation
(2) Setting
(3) Print position
The ribbon consumption might be different from the value in the above table depending on the ribbon
condition.
336 S84-ex/S86-ex Operator Manual
<Label>
Print data
(A)
Print data
Backfeed
Dispense distance 14 mm (0.55")
PITCH and OFFSET of OFFSET VOLUME should be set to 0.00,
PITCH OFFSET should be set to 0.
Vertical print position is V001.
Print speed
Distance (A)
(inches/sec)
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
<Ribbon>
Print data
Print data
(unit: mm)
Ribbon
consumption (B)
4.0 2.5
4.0 2.5
4.0 2.5
4.0 2.5
4.0 2.5
4.0 2.5
4.0 2.5
4.0 3.0
4.0 3.0
4.0 3.5
6.0 3.5
8.0 5.5
9.0 7.5
11.0 9.0
13.0 11.0
(B)