SATO S84ex Operator's Manual page 343

When the data is consisted with all printable characters, the dump data will be a maximum of thirty-two
characters in ASCII. When there is a non-printable character or a control code that are non-printable, the
dump data will be a maximum of sixteen bytes in HEX. Sixteen bits character codes, such as Kanji, are
not supported.
When the media size is not specified with the <A1> command, the error message and slash are printed
in a small layout as shown below, since the origin to be referenced is not clear.
WRITE TAG ERROR in RFID write
command
TAG NOT FOUND error in RFID
write command
Dump data in HEX for the first sixteen bytes of the write
data, or the maximum thirty two characters in ASCII.
The dump data will be in HEX when non-printable
characters and control characters are included in the data.
WRITE TAG
ERROR
4330313233353637
3839414243444546
TAG NOT
FOUND
3031323334353637
3839414243444546
READ TAG ERROR in tag data
print command <TU>
READ TAG
ERROR
TAG NOT FOUND error in tag
data print command <TU>
(INVENTORY CHECK is enabled)
TAG NOT
FOUND
S84-ex/S86-ex Operator Manual
8 Appendix
341