Ricoh D146 Service Manual page 90

[Admin. Authentication]
If this setting is off, tell the customer this setting must be on before you do the installation
procedure.
3. Make sure that "Administrator Tools" is enabled (selected).
[System Settings] -> [Administrator Tools] -> [Administrator Authentication Management] ->
[Available Settings]
If this setting is disabled (not selected), tell the customer this setting must be enabled
(selected) before you do the installation procedure.
Installation Procedure
1. Connect the network cable if it needs to be connected.
2. Turn on the main power switch.
3. Go into the SP mode and push "EXECUTE" in SP5-878-001.
4. Exit the SP mode and turn off the operation switch. Then turn off the main power switch.
5. Turn on the machine power.
6. Do SP5-990-005 (SP print mode Diagnostic Report).
7. Go into the User Tools mode, and select [System Settings]
Erase Memory Setting]
8. Exit the User Tools mode.
Icon [1]
Icon [2]
SM
[On].
This icon is lit when there is temporary data to be
overwritten, and blinks during overwriting.
This icon is lit when there is no temporary data to be
overwritten.
2-19
Main Machine Installation
[Administrator Tools] [Auto
D146/D147/D148/D149/D150