Ricoh D146 Service Manual page 250

13. Switch the power ON.
14. Press the [Default setting/counter] key.
15. Press the [Extension function default setting] button.
16. Press the [Extension function default setting] button on the [Extension function default menu
setting] screen.
17. Press the [Install] tab.
18. Press [SD card], and select "Extended JS" from the list of extension functions.
19. Select [MFP hard disk] as the installation location, and press [Next].
20. After checking extension function information on the "Installation preparation complete"
screen, press the [Enter] button.
21. "The following extension functions are already installed. The message "Overwrite extension
function?" is displayed. Press the [Continue] button.
22. When installation is complete, the message "Extension function has been installed" is
displayed. Press the [OK] button.
23. On the "Startup settings" tab, set [Extended JS] to the startup standby state, and switch the
power OFF.
24. Remove the SD card from SD card slot 2, and return the controller cover.
25. Switch the power ON.
26. Press the [Default setting/counter] key.
27. Press the [Extension function default setting] button.
28. Press the [Extension function default setting] button on the [Extension function default menu
setting] screen.
29. Check the version of [Extended JS] on the "Startup settings tab" is the latest version.
§
If the power is ON before starting Step 1, switch the power OFF after first performing
Steps 5-9, and perform Step 1 and subsequent steps. In that case, skip Steps 5-10. (This
saves time.)
§
If you do not plan to update Extension JavaScript, return the controller cover to the
original position after performing Step 5.
SM 2-179 D146/D147/D148/D149/D150
Browser Unit Type M4/M3