Ricoh D146 Service Manual page 529

SC No. Level
SC No. Level
SC505-41 B
SM
Error Name/Error Condition/Major Cause/Solution
§
Reset the paper
§
Remove the foreign matter
§
Replace the motor
§
Reset the connector
§
Replace the harness
§
Replace the sensor
§
Replace the control board for the optional paper feed tray
§
Replace the tray
§
Replace the paper feed roller
§
Replace the pick-up arm
Error Name/Error Condition/Major Cause/Solution
Side LCIT Limit Detection Error
§
Upper limit detection error (during descent)
During tray initialization (upper limit detection/lower limit not
detected), the tray base plate is lowered to check the tray
base plate position, but the limit sensor is detected although
a predetermined time elapsed.
§
Upper limit detection error (during ascent)
During tray initialization (upper limit not detected /lower limit
detection), the tray base plate is raised to check the tray
base plate position, but the limit sensor is not detected
although a predetermined time elapsed.
*If an error occurs for 3 times consecutively: the side LCIT
transmits a "5th paper feed tray upper limit detection error"
to the main machine.
Up to 2 times consecutively, the side LCIT transmits a "tray
set fault" to the main machine.
5-55
Service Call 501-584
D146/D147/D148/D149/D150