Ricoh D146 Service Manual page 523

SC No. Level
SC503-33 B
SM
Error Name/Error Condition/Major Cause/Solution
§
Lift motor error/connector missing
§
Lower limit sensor error/connector missing
§
Harness broken
§
Bank control board defective
§
Foreign matter, such as paper scrap, is caught between the
right tray and the tray lift motor
§
Paper set fault
§
Timing belt damage/dropout
§
Timing pulley damage/dropout
§
Base plate damage/horizontality fault
§
Foreign matter, such as paper scrap, is caught inside the
right tray
§
Reset the paper
§
Remove the foreign matter
§
Replace the motor
§
Reset the connector
§
Replace the harness
§
Replace the sensor
§
Replace the control board for the optional paper feed tray
§
Replace the tray
§
Replace the timing belt
§
Replace the timing pulley
§
Replace the base plate
3rd Tray Paper Overload Error (LCIT)
During tray initialization, both the upper limit and lower limit are
detected 3 times consecutively.
(up to 2 times consecutively, LCIT transmits "tray set fault" to the
main machine)
5-49
Service Call 501-584
D146/D147/D148/D149/D150