Table of Contents
Advertisement
Fit the pick-up sensor (17) in its seat in the crankcase half.
Start the screw (18) with the washer (19) and tighten to a torque of 10 Nm (Min. 9 Nm - Max. 11 Nm).
Use a feeler gauge to check the clearance between the engine sensor (17) and the timing gear (23).
The value must be between 0.6 and 0.8 mm.
Fit on the casing the ball (25), spring (26), pad (24) and tighten bush (21) with gasket (22) to a torque of
10 Nm (Min. 9 Nm - Max. 11 Nm).
Advertisement
Table of Contents
