Immobilizer System; Activations Through Diagnosis Instrument; Programming The Immobilizer System; Programming Procedure - Ducati SCRAMBLER 800 Workshop Manual

Hide thumbs Also See for SCRAMBLER 800:
Table of Contents

Advertisement

Immobilizer system

To increase protection against theft, motorcycle features an electronic engine locking system
(IMMOBILIZER) which is automatically enabled upon every Key-Off. Inside of each key handgrip there is an
electronic device that modulates the signal sent by a special antenna integrated in the ignition switch upon
starting. Such modulated signal represents the "password", that changes upon every starting, that allows
the control unit to acknowledge the key and thus starting the engine.

Activations through diagnosis instrument

The DUCATI diagnosis instrument allows performing a series of activations to check some instrument panel
functions and resetting parameters or warning lights.
After each activation, the instrument panel will restore its standard functions.
Note
The activations must be performed only with key turned to ON, engine off and battery voltage ≥ 11.0 V.
Immobilizer (keys) reset
This activation allows "erasing" the "keys" to reprogramme the Immobilizer System.
Upon receiving this request, the instrument panel resets the previously stored keys.
Upon next Key-On, the Immobilizer System will be "virgin" and it will be possible to reprogramme new
keys.

Programming the Immobilizer System

When replacing the instrument panel with a new one or when reprogramming the Immobilizer System
(because one or both keys got lost).
If the System is "virgin", upon Key-On the instrument panel immediately activates the "Immobilizer
Programming" mode.

Programming procedure:

- insert KEY 1 (one of the two black keys) and turn the key from Off to On;
- within 3 seconds turn the key from On to Off;
- within 15 seconds insert KEY 2 (the other black key) and turn the key from Off to On;
- within 3 seconds turn the key from On to Off;
- within 15 seconds insert KEY X again (no matter if Key 1 or Key 2) and turn the key from Off to On.
- If the procedure was successful the instrument panel shows "PROG." and "OK" for 3 seconds and then
switches to the standard display mode.

Advertisement

Table of Contents
loading

Table of Contents