Table of Contents
Advertisement
Every two oil changes, clean the oil intake mesh filter.
Remove the exhaust system
(Removing the exhaust
system).
Loosen outer plug (4) and collect seal (5).
Loosen the filtering element (6) and slide it out.
Clean the filter with fuel and compressed air. Take care not to damage the mesh. Refit mesh filter (6), seal
(5) on plug (4) and tighten it to a torque of 42 Nm (Min. 38 Nm - Max. 46 Nm).
Restore proper engine oil level.
Remove the filler plug (2) and carry out refilling with the specified oil type up to reaching the notch that
identifies the MAX level in the sight glass (7).
Refit the filler plug (2). Run the engine at idle speed for a few minutes.
Advertisement
Table of Contents
