Refitting The Gear Change Control - Ducati SCRAMBLER 800 Workshop Manual

Refitting the gear change control

Grease the two O-rings (10) and the gearchange lever pin (12), except its thread, with indicated product.
Insert pin with O-ring (10) fully home in gearchange lever.
Fit the second O-ring (10) on the shaft.
Start the gearchange lever pin (8), the two O-rings (10) in the LH footpeg holder plate.
Fit plate (4) fully home in its seat on the footpeg holder.
Start nut (3) and tighten it to a torque of 22 Nm ± 5%.
Position rod (2) and fix it to the gearchange lever (8) by means of screw (7).
Tighten the screw (7) to a torque of 10 Nm ± 10%.