Table of Contents
Advertisement
Refitting the ABS control unit
In case of replacement or removal of the hoses (3), (4), (5) and (6) on the ABS control unit, it is necessary
to pay special attention to the union position on the control unit.
Warning
If incorrectly positioned, hoses can affect brake operation and foul moving parts. Position the component as
shown in the figure.
X=77°
Y=90°
Z=5°
Hoses (3), (4), (5) and (6) must be secured in place using new sealing washers (2) on unions.
Fasten the ABS control unit (8) by tightening the screws to the torque of 6.8 Nm ± 10%.
Tighten screws (1) securing the hoses indicated below to the ABS control unit to a torque of 23 Nm ± 10%:
ABS control unit hose to front brake master cylinder (3);
ABS control unit hose to front brake calliper (4);
ABS control unit hose to rear brake master cylinder (5);
ABS control unit hose to front brake calliper (6).
Advertisement
Table of Contents
